How to Test RF Test Cables?

Published by

admin

2022-12-30

Testing RF Test Cables is a simple process. However, you will need some basic equipment: a multimeter. Also known as a volt-ohmmeter, this device measures current, resistance, voltage and other important performance details. Both analog and digital versions are available on the market today.
rf test cable, vna cable, vna test cable, rf test cables
Once you have your multimeter ready, you can test your RF Test Cables. Make sure the RF Test Cables are not connected to anything. then perform your RF Test Cables test by following a few basic steps: Touch each probe to one end of the RF Test Cables. Place the probe's tip on the outside of the inner ring inside RF Test Cables end. Check the multimeter's readout. Remember to subtract the internal resistance figure from your earlier test from the meter's measurement. The final result should be near 0 ohms. Touch the probes to the center pin in each cable's end. Check your reading and subtract your internal resistance measurement. This figure should also be close to 0 ohms.