BLOG_Custom RF Coaxial Cables, Coaxial Cable Assembly, RF Connector

Pre-assembly measurements in isophase stable cable using the net-split VNA(2)

2023-09-11

Pre-assembly measurements in isophase stable cable using the net-split VNA(2)

Measurement of phase match of phase stable cable If the phase of the reflection parameter (S11) is measured at one port of the cable instead of the phase of the transmission parameter (S21), the requirement of consistency in the installation of the cable

Vistor

Pre-assembly measurements in isophase stable cable using the net-split VNA(1)

Published by:

admin

2023-09-11

Pre-assembly measurements in isophase stable cable using the net-split VNA(1)

Certain systems require strict phase matching and therefore demand phase consistency of the transmission parameters (S21) of multiple cables at certain frequency points. In the actual production process, only by strictly controlling the length of the cabl

NMD adapters which cover five major millimeter-wave adapters

The network analyzers from Keysight (formerly Agilent) are well recognized by RF engineers and have a large user base. Its NMD Adapters for VNA test cables belong to the reinforced test port connectors, commonly used diameters of 3.5mm, 2.92mm, 2.4mm and

ZOMWAVE Provides High Power RF Loads/RF Terminators

Many test, R&D, and production applications require RF Loads/RF Terminators to terminate coaxial cables, multi-couplers, and test equipment. To meet the needs of these applications, ZOMWAVE provides high power RF Loads/RF Terminators that can be used

When do we need to use a RF Terminator?

In many applications, there are unused coaxial ports, which can lead to signal leakage and crosstalk from neighboring equipment. W

What are the uses of RF Terminator / RF Load?

The RF Terminator / RF Load is essentially a more ideal 50 ohm resistor, which is used in two main ways: 1, in the RF test process, not in use port needs to be connected to match the load, used to absorb the port energy, to avoid signal reflection, affec

The Definition and Function of RF Terminator / RF Load

Definition of RF Terminator/RF Load. Coaxial loads are microwave passive single-port devices that are widely used in microwave equipment and microwave circuits. Function of RF Terminator/RF Load.: The main function of the RF Terminator/RF L

Analysis of the causes of rf coaxial connector failure and solutions(2)

Incorrect size of the jack or pin of the inner conductor If the hole diameter of the conductor in the jack is smaller than the specified size, when the pin of the conductor in the jack enters the jack, the jack will over-expand and deformation will exc

Vistor